This blog will show the installation of a 6 x 6 wedi shower bases with curbs, walls, custom soap niche, and custom built bench supplied by Masonry & Glass Systems. The 6 x 6 base was installed first (6 x 6 wedi base). The walls were then installed using wedi sealant and screws and washers (Photo 1).

Please note how tight the fit is between the wall board and the shower head supply pipe (Photo 2).

The bench was built from 2 x 8 x 2 inch wedi board custom cut to fit (Photo 3 & 4).

The soap niche was built from 3 x 5 x ½ inch wedi board with 2 x 4 support behind the wedi board (Photo 5).

The curb was then installed. The miter cut was on the money and so resulted in a nice tight joint (Photo 6).

The overall result is a waterproof, mold proof, and mildew proof shower that will not puddle and is ready for tile (Photo 7).

Masonry & Glass Systems stocks most Wedi products for immediate pick up or shipment.

Masonry & Glass Systems can ship Wedi shower system base almost anywhere. We ship custom Wedi Shower Systems every week!

We ship to all 48 lower states!

Call us Mon-Fri at 314-535-6515

or

click the link below to receive a free quote for your Wedi Shower System Base

If you or someone you know is looking for the Wedi Backer Board to complete a glass block shower project, a doorless shower or any other bathroom project where water and moisture is a risk, please contact Masonry & Glass Systems in St. Louis.  For more information, email them at: [email protected] or call 314-535-6515